EWC-ST-2E and Briggs and Stratton Automatic Transfer Switch

[Rennoc]

The Supervisory Control Wiring diagram for the ATS says to connect 24 VAC wiring from the terminals on the transfer switch supervisory terminals to the Air Conditioner Contactor Controller. Which terminals should this be connected to on the EWC-ST-2E? This is in order for the transfer switch to gauge whether or not enough generator power is available to run the ac.

[Erik W.]

Your transfer switch does not connect to the EWC panel at all. We here at EWC Controls are not licensed electricians so we can not advise you on how to properly hook up your transfer switch.

Erik Wnoroski
EWC Controls, Inc.
385 State Route 33
Englishtown, NJ 07726
800-446-3110 ext 483