Jumpering zone motor outputs together

Post your questions and comments here.
Post Reply
79Bry
Posts: 2
Joined: Wed Jan 10, 2024 9:40 am

Jumpering zone motor outputs together

Post by 79Bry »

Hello,

I have a BMPlus3000 rev B control panel connected to my HVAC system.

I'd like to have 2 second floor thermostats (wired to ZONE2 T'STAT and ZONE3 T'STAT) controlling a single zone (ZONE2) of dampers (SID6 and SID8) on my second floor. Is there anything inherently unsafe or wrong with jumpering the control panel's ZONE2 MOTOR output to the ZONE3 MOTOR output so that regardless of which/both thermostat is calling for heat/cool ZONE2 would be energized at the board's output and thus opening all my second floor dampers?

Thank you,
Bryan
Steven W.
Posts: 113
Joined: Tue Jun 25, 2019 9:13 am

Re: Jumpering zone motor outputs together

Post by Steven W. »

You sure can. There is nothing wrong with that.
Steven R. Weisneck
Technical Engineer
Tel: (732) 446-3110 Ext. #461
www.ewccontrols.com
sweisneck@ewccontrols.com
79Bry
Posts: 2
Joined: Wed Jan 10, 2024 9:40 am

Re: Jumpering zone motor outputs together

Post by 79Bry »

Thank you. I just got around to making this change yesterday, it works great.

Thanks again!
Bryan
Post Reply