BMPlus3000 with Single Stage Furnace

[TTJJJJ]

Hello,
I recently purchased the BMPlus3000 Zone controller to replace my ST version. I figured that the extra zone, the better thermostat options, and the compatibility with 2 stage furnaces (for future furnace upgrade) made it worth the extra for the better controller. Well, I hooked everything up yesterday and I *think* it is working properly. The problem is that the wiring diagram doesn't show a wiring scheme for a single stage furnace with only 4 system wires.

My old ST controller had wires from the furnace connected to the system terminals Y, W, G, Rc.

I connected these to the Y1, W1, G, R terminals on the BMPlus300 and the heat seems to be working ok. The 3 zone dampers cycled upon startup and I think I am good. I just wanted to be sure that it is hooked up right.

Thanks for selling and supporting these great products!

Tim

[Pcyrana]

Your welcome Tim.
Thank you for your support as well!