Econet Zone Control shows no temperature

Post your questions and comments here.
Post Reply
cdg2000
Posts: 1
Joined: Tue Nov 29, 2022 1:10 pm

Econet Zone Control shows no temperature

Post by cdg2000 »

Hello,
I installed a three zone panel EcoNet REPNL700ZON to my new Rhem air conditioner. I also installed 3 EcoNet Zone controls RECTL7000ZON in addition to the main EcoNet thermostat SYS model.
Everything talks to each other, but none of the Zone Thermostats display a Temperature. They display ---- (two dashes), humidity is well measured. The main thermostat sees the three zones and reads the humidity from each zone, but then reads 0 degrees tempearture.
I have tried everything possible and checked all settings. I am starting to suspect a physical issue with the Thermostat temperature sensor, but in all three. I just them together just a week ago, and they are like this from the beginning.
Anyone has an idea what could be the problem? Rheem support is not existent.Thanks
Steven W.
Posts: 110
Joined: Tue Jun 25, 2019 9:13 am

Re: Econet Zone Control shows no temperature

Post by Steven W. »

Give us a call when you get a chance
Steven R. Weisneck
Technical Engineer
Tel: (732) 446-3110 Ext. #461
www.ewccontrols.com
sweisneck@ewccontrols.com
Post Reply