Zoning not heating correctly for EWC ST 3D

Post your questions and comments here.
Post Reply
Suyogbidkar
Posts: 1
Joined: Wed Jan 19, 2022 12:46 pm

Zoning not heating correctly for EWC ST 3D

Post by Suyogbidkar »

I am new home owner and have EWC ST 3D panel as attached.

Zone 1 - master and on first floor
Zone 2 & 3- are on 2nd floor

Problem- whenever heating starts on first floor it starts to heat on zone 2 and 3( 2nd floor)automatically. I have tried reducing the temperature for zone 2 & 3 but didn’t help. If i set zone 1 to 68 degree then 2nd floor ( zone 2 & 3) are reaching 80degree plus even when zone 2 & 3 are turned off.

P.S- I am able to start zone zone 2 heating without heating zone 1 ( say i set zone 1 to 64degree and zone 2 to 68 degree then just zone 2 will heat as expected) but vise versa is not working and causing overheating of 2nd floor.

Any suggestion to fix this ?
You do not have the required permissions to view the files attached to this post.
Steven W.
Posts: 105
Joined: Tue Jun 25, 2019 9:13 am

Re: Zoning not heating correctly for EWC ST 3D

Post by Steven W. »

Sounds like Zone 2 and Zone 3 Zone dampers are not closing. That's why its getting so hot upstairs. I would recommend you get a HVAC Contractor out to your house to take a look at that.
Steven R. Weisneck
Technical Engineer
Tel: (732) 446-3110 Ext. #461
www.ewccontrols.com
sweisneck@ewccontrols.com
Post Reply