is it possible to update the software on a UT3000?

Post your questions and comments here.
Post Reply
1stbscout
Posts: 3
Joined: Thu Jun 08, 2023 5:17 pm

is it possible to update the software on a UT3000?

Post by 1stbscout »

I have a UT3000 ver.1.19 board on my Amana invertor system. I have been working on "ways" to get a communicating system smart thermostat to work with said system. I connected a Daikin One+ thermostat to the zone controller and could not get it to communicate with the board. But if I connected it directly to the equipment bypassing the board it did find and communicate with the equipment.
Is this due to a change in the software for the later UT300 boards?
Steven W.
Posts: 114
Joined: Tue Jun 25, 2019 9:13 am

Re: is it possible to update the software on a UT3000?

Post by Steven W. »

Give us a call when you get a chance
Steven R. Weisneck
Technical Engineer
Tel: (732) 446-3110 Ext. #461
www.ewccontrols.com
sweisneck@ewccontrols.com
Juliet89
Posts: 1
Joined: Tue Jul 23, 2024 7:04 am

Re: is it possible to update the software on a UT3000?

Post by Juliet89 »

Yes, it is possible to update the software on a UT3000. Typically, you would need to download the latest firmware from the manufacturer's website and follow the specific update instructions provided. Ensure you have a stable power source and follow all steps carefully to avoid any issues during the update process. Always back up your current settings before proceeding...
Last edited by Juliet89 on Sat Jul 27, 2024 6:17 am, edited 1 time in total.
Steven W.
Posts: 114
Joined: Tue Jun 25, 2019 9:13 am

Re: is it possible to update the software on a UT3000?

Post by Steven W. »

You can update the software. But we have to do it in house for you we do not have anything online to update your zone board.
Send me your email (off this forum) and I will give you all the INFO. (tech@ewccontrols.com)

Thanks
Steven
Steven R. Weisneck
Technical Engineer
Tel: (732) 446-3110 Ext. #461
www.ewccontrols.com
sweisneck@ewccontrols.com
Post Reply