UT 3000 closes all dampers and ramps up blower

Post your questions and comments here.
Post Reply
Itsalwayssomething
Posts: 1
Joined: Mon Nov 14, 2022 10:13 pm

UT 3000 closes all dampers and ramps up blower

Post by Itsalwayssomething »

Recently installed an ewc zone system on daikin modulating furnace and modulating inverter heat pump. Two zone boards to control 4 zones. System seems to operate normally when using heat pump but as soon as Daikin One thermostat is put into emergency heat mode (furnace) all dampers will close and the blower ramps up to full speed. Also if you lightly wipe the clear cover on the zone controller the board will cycle off and on.
Steven W.
Posts: 113
Joined: Tue Jun 25, 2019 9:13 am

Re: UT 3000 closes all dampers and ramps up blower

Post by Steven W. »

Can you give us a call when you get a chance.

1-800-446-3110
Steven R. Weisneck
Technical Engineer
Tel: (732) 446-3110 Ext. #461
www.ewccontrols.com
sweisneck@ewccontrols.com
Post Reply