Maybe this question has been asked before, but I couldn't find it when I did a search.
I want to replace my current thermostat with a Honeywell Home Wi-Fi Smart Color Thermostat. It talks about a 'C' wire. I don't see a 'C' wire connected to either the Zone 1 or Zone 2 T'Stat connectors. I do see that there is an extra wires (blue & brown) that are wrapped around the wire going to each zone thermostat. My question, if I use the extra wire to connect to the 'C' connector, will I have a problem? Is there power to the 'C' connector on the board? See attached photo. Do I need to get a professional to do the thermostat replacement?
Help appreciated.
Smart Tstat on NCM-300 board
Smart Tstat on NCM-300 board
You do not have the required permissions to view the files attached to this post.
Re: Smart Tstat on NCM-300 board
Yes you can use one of the spare wires for the "C" wire
Steven R. Weisneck
Technical Engineer
Tel: (732) 446-3110 Ext. #461
www.ewccontrols.com
sweisneck@ewccontrols.com
Technical Engineer
Tel: (732) 446-3110 Ext. #461
www.ewccontrols.com
sweisneck@ewccontrols.com