Post your questions and comments here.
3 posts • Page 1 of 1
]Hi, I have replaced my EWC-ST-2D panel with an NCM-300 and followed the upgrade wiring instructions. I wired the NCM-300 exactly the same as the ST-2D on the system block (see attachements). I have a gas-fired furnace and external AC unit with 2 zones. The reason for the upgrade is to be able to install Nest thermostats. I have not yet installed the Nests, keeping the existing thermostats connected. After turning on the system and having a zone call for heat, the system seems to run as expected, and delivers heat to the correct zone for several minutes. I then hear what sounds like a relay clicking from the furnace and the NCM-300 shuts completely off, as if there was a short, no LEDs. I tried this on both zones and the system acted exactly the same for both. Is there an issue with the way my system is wired?
You do not have the required permissions to view the files attached to this post.