Which zone control to use?

[Tlwilk]

I just replaced my ground source heat pump. Old unit was a water furnace premier with intellizone control board for dampers control. New is a climatemaster tranquility 30 (model te064). I have two zones using water furnace ZACT dampers and Honeywell TH8329U thermostats. The heat pump has a variable speed fan.

I was looking at either BMPlus 3000 or NCM-300. No other controls installed. The intellizone board controlled the blower on the original installation and I don't think that is compatible with the climatemaster.

Thanks, Tom

[Erik W.]

You can use either a bmplus 3000 or a ncm 300. Use the bmplus for two stage operation and the ncm 300 if you have single stage.

Erik Wnoroski
EWC Controls, Inc.
385 State Route 33
Englishtown, NJ 07726
800-446-3110 ext 483

[Tlwilk]

Thanks. I will go with the BMPlus 3000 since it is a two stage unit. Any special wiring issues?

[Erik W.]

No special wiring, there is a diagram provided in the technical bulletin you will receive upon purchasing the panel.

[Tlwilk]

0BEB5FE2-127D-4B8F-9AF0-B68AACD8947B.jpeg

Resurrecting this thread from the past. One of my water furnace ZACT actuators constantly runs. What is a good replacement actuator? It is a 3 wire rectangular actuator.

[Steven W.]

I got some questions please give me a call (732)-446-3110 x461