NCM 300 - Zone Issue

Post your questions and comments here.
Post Reply
dmann090611
Posts: 1
Joined: Sat Oct 16, 2021 9:17 am

NCM 300 - Zone Issue

Post by dmann090611 »

I had a new system installed in April 2021, system has a total of 4 zones, First floor and used EWC ND 5 dampers to control 3 room in a finished basmt. we used Nest Tstat in bsmt. The control of zones is not working at all correctly, each tstat controls 2 zones, not the related zones associate with the tstat zone 1 tstat opens zone 2 and 3 , tstat 2 controls zone 1 and 3 etc. i checked all wiring its associated correctly, zone 1 is zone 1 dampeners etc, only one , i take off the 24v and the power light on dampeners goes out. The board LED zone lights are suppose to be on when closed ,system not calling. they all stay light when no demand is calling. tried to troubleshoot with guide all shows ok. could the board be bad?
Steven W.
Posts: 40
Joined: Tue Jun 25, 2019 9:13 am

Re: NCM 300 - Zone Issue

Post by Steven W. »

It could be a bad board. But I am going to need you or some one there at the board to take some readings with a volt meter.

Can you give me a call.

Steven R. Weisneck
HVAC Zoning Technician
Tel: (732) 446-3110 Ext. #461
www.ewccontrols.com
sweisneck@ewccontrols.com
M-F 8:00am - 4:30pm
Steven R. Weisneck
Technical Engineer
Tel: (732) 446-3110 Ext. #461
www.ewccontrols.com
sweisneck@ewccontrols.com
Post Reply