Ruud econet system with EWC ECONET 3 zone panel acting strange

Post your questions and comments here.
Post Reply
Btettemer
Posts: 1
Joined: Tue May 04, 2021 10:51 am

Ruud econet system with EWC ECONET 3 zone panel acting strange

Post by Btettemer »

I installed the following equipment last July

1-Ruud condenser model UA1736AJ2CB
1- Ruud furnace model U96VA0852521MSB
1- Ruud coil model RCF3621MTAMCA
1- Ruud Econet Thermostat UETST700SYS
2- Ruud Econet zone controllers model RECTL700ZON
1- EWC ECONET zone control panel
3- various size EWC ND motorized dampers

The customer brought to my attention the system wasn't cooling. When I arrived I found that even though all 3 t stats were calling for cooling only the 1st zone (main controller) was lit up in the panel. In addition, the condenser would not come on. There is no error codes on the furnace, condenser, or the thermostat. So I shut it down and powered it back up. All 3 zones lit up and then shut off except for zone 1 again.

The system has worked fine for almost a year. Your thoughts on a zone panel issue?
Steven W.
Posts: 40
Joined: Tue Jun 25, 2019 9:13 am

Re: Ruud econet system with EWC ECONET 3 zone panel acting strange

Post by Steven W. »

You are going to need to call Rheem / Rudd the Econet is there board we do not take any Tech calls on that board.
Rheem / Rudd will answer any questions for you.

RHEEM / RUDD Tech Number 1-800-255-2388
Steven R. Weisneck
Technical Engineer
Tel: (732) 446-3110 Ext. #461
www.ewccontrols.com
sweisneck@ewccontrols.com
Post Reply