UZC4 - 3rd and fourth stage do not start

Post your questions and comments here.
Post Reply
CollertJ
Posts: 1
Joined: Thu Jan 31, 2019 12:43 pm

UZC4 - 3rd and fourth stage do not start

Post by CollertJ »

I have a Bard geothermal furnace with 4 stages of heat - 2 compressor and 2 electric coil heat. With the recent cold snap, our furnace was unable to keep up and I noticed only the first 2 stages were running. I turned off all stats and then back on and waited over an hour and only the 2 compressor stages were running. I switch to emergency heat and the electric coil heat worked. Any ideas on why stage 3 is not starting?
Paul Z.
Posts: 216
Joined: Thu Dec 08, 2011 3:05 pm

Re: UZC4 - 3rd and fourth stage do not start

Post by Paul Z. »

Call 18004463110X490 have a few questions.
Post Reply