Troubleshooting Steps for Zone airflow issue

Post your questions and comments here.
Post Reply
JonC
Posts: 1
Joined: Fri Nov 30, 2018 2:41 pm

Troubleshooting Steps for Zone airflow issue

Post by JonC » Fri Nov 30, 2018 2:54 pm

Hi,

I'm trying to troubleshoot an airflow issue of a 14 yr old house.
I have an NCM-300, 2 zones.
Zone 1 is upstairs. Zone 2 is downstairs.
My downstairs zone seems to have airflow fine.
My upstairs airflow has stopped. I checked the duct infront of the flapper, and it was closed, and seems to stay closed. The NCM shows both Zone 1 and 2 open (red LED), but I don't think I've ever seen the LEDs off, except for zone 3 which is not used.
I manually opened the closed flapped upstairs, but at some point, the system turned on and I the flapper was closed at some point.
I pulled the flapper actuator, and connected to zone 3 output at the NCM, and the little motor slowly moved.
I tested voltage for each zone output. Without motor attached, I see 28 volts. With motor attached, 5 volts.
I did find an issue with the NCM with possibly cold solder joints on zone 3 relay (opens and closes when lightly touched), but zone 1 and 2 don't seem to exhibit this behavior.
I'm trying to determine the next troubleshooting steps before buying a new actuator or a new controller board.
I'm suspecting actuator is the issue.
Are there any additional troubleshooting steps that I should perform before buying parts? Do the actuators need to be adjusted or orientated to reset its position?
I appreciate any suggestions or help. thanks

Paul Z.
Posts: 207
Joined: Thu Dec 08, 2011 3:05 pm

Re: Troubleshooting Steps for Zone airflow issue

Post by Paul Z. » Mon Dec 03, 2018 7:48 am

Give a call 18004463110 X490

Post Reply