Which zone control to use?

Post your questions and comments here.
Post Reply
Tlwilk
Posts: 3
Joined: Sun Apr 13, 2014 6:44 pm

Which zone control to use?

Post by Tlwilk »

I just replaced my ground source heat pump. Old unit was a water furnace premier with intellizone control board for dampers control. New is a climatemaster tranquility 30 (model te064). I have two zones using water furnace ZACT dampers and Honeywell TH8329U thermostats. The heat pump has a variable speed fan.

I was looking at either BMPlus 3000 or NCM-300. No other controls installed. The intellizone board controlled the blower on the original installation and I don't think that is compatible with the climatemaster.

Thanks, Tom
Erik W.
Posts: 117
Joined: Fri Dec 07, 2012 11:23 am
Location: Englishtown, NJ
Contact:

Re: Which zone control to use?

Post by Erik W. »

You can use either a bmplus 3000 or a ncm 300. Use the bmplus for two stage operation and the ncm 300 if you have single stage.

Erik Wnoroski
EWC Controls, Inc.
385 State Route 33
Englishtown, NJ 07726
800-446-3110 ext 483
Tlwilk
Posts: 3
Joined: Sun Apr 13, 2014 6:44 pm

Re: Which zone control to use?

Post by Tlwilk »

Thanks. I will go with the BMPlus 3000 since it is a two stage unit. Any special wiring issues?
Erik W.
Posts: 117
Joined: Fri Dec 07, 2012 11:23 am
Location: Englishtown, NJ
Contact:

Re: Which zone control to use?

Post by Erik W. »

No special wiring, there is a diagram provided in the technical bulletin you will receive upon purchasing the panel.
Tlwilk
Posts: 3
Joined: Sun Apr 13, 2014 6:44 pm

Re: Which zone control to use?

Post by Tlwilk »

0BEB5FE2-127D-4B8F-9AF0-B68AACD8947B.jpeg
Resurrecting this thread from the past. One of my water furnace ZACT actuators constantly runs. What is a good replacement actuator? It is a 3 wire rectangular actuator.
You do not have the required permissions to view the files attached to this post.
Steven W.
Posts: 105
Joined: Tue Jun 25, 2019 9:13 am

Re: Which zone control to use?

Post by Steven W. »

I got some questions please give me a call (732)-446-3110 x461
Steven R. Weisneck
Technical Engineer
Tel: (732) 446-3110 Ext. #461
www.ewccontrols.com
sweisneck@ewccontrols.com
Post Reply