EWC Controls Forum

1stbscout, Sounds like you had a real adventure getting this equipment to work... Actually, the term ComfortNet is what Goodman uses to identify their Climate Talk family of equipment. So they are not different...Goodman's ComfortNet family is utilizing the Climate Talk open protocol. In a fully ...

That is correct...The ComfortBridge indoor unit simply needs a W signal for Heat or a Y signal for Cool.

This is the case, even if the ComfortBridge system is a Heat Pump.

John

Kevin, First off, the UT3000 can be used in non-communicating mode, to operate your ComfortBridge family of equipment, if full communicating mode cannot be achieved. I assume your Outdoor unit is also communicating? Perhaps a two stage unit or an Inverter? All communicating outdoor units are still ...

Joylove, Thanks for the equipment specs...They may come in handy. As you may or may not know, we have been working with Daikin on the CT protocol, for their FIT line of communicating equipment and the Daikin One communicating thermostat. As a result, the UT3000 firmware evolves to maintain ...

Joylove, It's great that your ComfortBridge system can be fully controlled by the UT3000. We have received some reports of successful ComfortBridge installations using our patented UT3000 controller. However, these jobs are very few and far in between. Successful UT3000/ComfortBridge (fully ...

Recently, we have received numerous tech calls from frustrated Contractors who cannot achieve control (communication) between the Ultra-Zone UT3000 zone controller and Goodman "ComfortBridge" rated HVAC equipment. This is because ComfortBridge "indoor units" are designed to work with "legacy" non ...

Sir, Your MA-ND5 motor actuators are compatible with Rheem/Ruud EcoNet communicating HVAC systems. The MA-ND5 motor actuator is a "floating Point" actuator that modulates via the EcoNet zone controller, as it receives commands from the Primary/Master thermostat for all connected zones on the network ...

meassick, Sorry for the late response. We have had extremely high tech call volume and have not paid sufficient attention to the forum. Sir, it appears that someone has programmed one or both CTK04's to "humidify" without heat!....This is a function in the "Installer Menu" of each CTK04 thermostat ...

tnormile, Sorry for the late response. We have had extremely high tech call volume and have not paid sufficient attention to the forum. Sorry your BMP failed and it appears the BMP was powered via the same 24vac transformer in the furnace, rather than a dedicated transformer, as specified in the ...

Eddie23, Sorry for the late response...We have had extremely high tech call volume over the last 6 months and have not paid sufficient attention to the forum. You don't have to use the "SAS" supply air sensor but we highly recommend it. If you decide to install and use it, drill the hole in the ...