Search found 3 matches
- Wed Jan 25, 2012 9:47 am
- Forum: Help and Advice
- Topic: Oil Furnace Constantly Running
- Replies: 4
- Views: 17022
Re: Oil Furnace Constantly Running
Hi Guys, OK here is the scoop. When the thermostats are satisfied the LEDs on the NCM300 are #1 (system) flashing and #3-5 (Zone Dampers 1-3) steady on. #7 (fault) is not on as are no others. With a reset of the furnace itself, the burner power switch not the circuit breaker, the system resets and ...
- Thu Jan 19, 2012 11:16 am
- Forum: Help and Advice
- Topic: Oil Furnace Constantly Running
- Replies: 4
- Views: 17022
Re: Oil Furnace Constantly Running
The next time it does this I will get back to you guys.
It may be a couple of days to check, since I had to reset the system this AM.
I spoke to Bob, I think, and he told me the same thing and how to check it all.
For the record the Ver is 1.2 on the chip.
I'll get back to you.
Thank you.
It may be a couple of days to check, since I had to reset the system this AM.
I spoke to Bob, I think, and he told me the same thing and how to check it all.
For the record the Ver is 1.2 on the chip.
I'll get back to you.
Thank you.
- Thu Jan 19, 2012 10:04 am
- Forum: Help and Advice
- Topic: Oil Furnace Constantly Running
- Replies: 4
- Views: 17022
Oil Furnace Constantly Running
I have a Ruud Oil Furnace with a NCM300 Panel and 2 zones. This was installed 5 years ago and never had an issue until lately. Not always but often the zones stop calling for heat yet the furnace itself, fan too, does not shut down. This has required a power-off of the whole system, on re-energizing ...