Patrick,
That fixes the issue.
Just because, I tested the a/c side as well and that appears to work.
THANK YOU very much. This was (relatively) painless and definitely directly to the point.
Have a fantastic Christmas season!
Search found 5 matches
- Fri Dec 02, 2011 1:07 pm
- Forum: Help and Advice
- Topic: Continuous fan in heat mode on NCM300 System
- Replies: 10
- Views: 25225
- Wed Nov 30, 2011 4:15 pm
- Forum: Help and Advice
- Topic: Continuous fan in heat mode on NCM300 System
- Replies: 10
- Views: 25225
Re: Continuous fan in heat mode on NCM300 System
Patrick, That likely explains it then. Unit is a Goodman Company Model ARUF486016CA and says it is heat pump. So the question then becomes, do I just disconnect the wire on the lower right of the controller motherboard (or should it be connected elsewhere?). Thanks in advance ...
- Wed Nov 16, 2011 10:57 am
- Forum: Help and Advice
- Topic: Continuous fan in heat mode on NCM300 System
- Replies: 10
- Views: 25225
Re: Continuous fan in heat mode on NCM300 System
Hi Patrick, The week got away on me, sorry. Lights on are: Status (blinks) Zone 3 Open Zone 2 Open Zone 1 Open W1/B If unit is reset, W1/B is off. Thermostats have Emerson name but sticker behind cover says it is a White-Rodgers Type 1F82-0261. The Emerson site says it is an Emerson Blue 2 which ...
- Fri Nov 04, 2011 1:23 am
- Forum: Help and Advice
- Topic: Continuous fan in heat mode on NCM300 System
- Replies: 10
- Views: 25225
Re: Continuous fan in heat mode on NCM300 System
Patrick,
I will get that for you tomorrow.
Interestingly, a reset causes the fan to stop, but in the documentation it states that the continuous fan mode will be on any time there is not a heat or cool request - which seemed odd for it to run longer than a purge cycle.
More to come - thank you.
I will get that for you tomorrow.
Interestingly, a reset causes the fan to stop, but in the documentation it states that the continuous fan mode will be on any time there is not a heat or cool request - which seemed odd for it to run longer than a purge cycle.
More to come - thank you.
- Tue Nov 01, 2011 12:23 pm
- Forum: Help and Advice
- Topic: Continuous fan in heat mode on NCM300 System
- Replies: 10
- Views: 25225
Continuous fan in heat mode on NCM300 System
Hi. I recently purchased a house with NCM300 Zone system. It has 2 zones (upstairs/downstairs) and appears to be wired for heat pump and has programmable thermostats up and down. When we arrived on the weekend we programmed the thermostats and turned on heat mode. The system heats to temperature but ...