Search found 108 matches
- Tue Apr 09, 2024 9:10 am
- Forum: Help and Advice
- Topic: NCM-300 - suitable for dual fuel, two stage heat pump?
- Replies: 1
- Views: 94
Re: NCM-300 - suitable for dual fuel, two stage heat pump?
Yes you need the BMPlus 3000 for duel fuel
- Tue Apr 09, 2024 9:09 am
- Forum: Help and Advice
- Topic: ComfortNet CTK01 Thermostat Replacement
- Replies: 2
- Views: 106
Re: ComfortNet CTK01 Thermostat Replacement
Yes the CTK04 will work
- Tue Apr 02, 2024 12:03 pm
- Forum: Help and Advice
- Topic: Replacement part
- Replies: 1
- Views: 115
Re: Replacement part
You need to Replace the whole damper. That motor is old we do not make it anymore. There is no replacement for that motor.
- Tue Mar 12, 2024 1:58 pm
- Forum: Help and Advice
- Topic: BMPlus 3000 with 4 zone 2 stage heat pump Questions/Need Help
- Replies: 2
- Views: 175
Re: BMPlus 3000 with 4 zone 2 stage heat pump Questions/Need Help
Give us a call when you are in front of the board we can help you out.
1-800- 446-3110
1-800- 446-3110
- Tue Jan 23, 2024 11:20 am
- Forum: Help and Advice
- Topic: Firmware upgrade for UltraTalk 3000
- Replies: 1
- Views: 772
- Tue Jan 23, 2024 11:19 am
- Forum: Help and Advice
- Topic: Is my MA-ND4 malfunctioning?
- Replies: 2
- Views: 1035
Re: Is my MA-ND4 malfunctioning?
The relay went on the MA-ND4 motor that controls the lights. Your damper should still open and close when it is supposed to. You just cant look at the lights now to see if it is open or closed.
- Tue Jan 23, 2024 11:15 am
- Forum: Help and Advice
- Topic: damper sticks open
- Replies: 2
- Views: 755
Re: damper sticks open
If its a old Trolatemp motor you are going to need to replace the whole damper.
- Wed Jan 10, 2024 11:07 am
- Forum: Help and Advice
- Topic: Jumpering zone motor outputs together
- Replies: 2
- Views: 1001
Re: Jumpering zone motor outputs together
You sure can. There is nothing wrong with that.
- Fri Dec 15, 2023 9:29 am
- Forum: Help and Advice
- Topic: NCM-300 heats for only for 3 mins
- Replies: 2
- Views: 2383
Re: NCM-300 heats for only for 3 mins
I would set the high limit between 160-170
- Thu Dec 07, 2023 10:27 am
- Forum: Help and Advice
- Topic: BMP3000 with OAS allow time out to furnace
- Replies: 1
- Views: 2088
Re: BMP3000 with OAS allow time out to furnace
It will take 30 minutes to stage up when you are using the OAS and the temp is above your set point